#UTTips - Penggantian Engine Oil & Engine Oil Filter

Summary

This video provides a step-by-step guide on how to replace engine oil and the oil filter. It highlights the importance of safety, explaining that the engine should cool down to avoid burns before starting the procedure. The video demonstrates how to drain the old oil, remove the filter, and install a new one while ensuring proper tightening to avoid leaks. It also covers checking the oil level using a dipstick and ensuring the correct oil capacity. Viewers are reminded to inspect for any leaks after completing the process.

Takeaways

• 🛢️ Ensure the engine oil is cooled down before starting to avoid burns.
• 📍 Place the machine in a safe and level position before opening the cover below the engine.
• 🛠️ Use a container to catch drained oil and carefully open the drain valve.
• 🔧 Use a filter wrench to remove the oil filter cartridge and prepare a container to catch any spillage.
• 🧼 Clean the filter holder thoroughly before installing a new oil filter.
• ⚠️ Check if the old packing remains on the filter holder and ensure it is removed before installing the new filter.
• 👌 Tighten the filter cartridge properly to avoid oil leakage, making sure it's not too tight or too loose.
• 🛑 After replacing the filter, open the engine hood and add oil until the level is between full and low on the dipstick.
• 📏 The engine oil capacity is 35 liters; always verify oil level with the dipstick after refilling.
• 👀 After running the engine briefly, inspect for oil leaks and adjust filter tightness if needed before closing the cover.

Q & A

What is the first step before performing an oil change on the engine?

The first step is to ensure that the engine oil and components have cooled down to avoid burns. It's important to wait until the oil temperature decreases before proceeding.

Where should the unit be placed before beginning the oil change process?

The unit should be placed in a safe and level area before starting the oil change procedure.

What should be done before draining the oil from the engine?

Before draining the oil, the cover located under the engine should be opened and a container should be prepared to collect the oil.

How should the oil be drained from the engine?

The drain valve should be opened slowly to let the oil drain into the container prepared earlier.

What tool is needed to remove the oil filter cartridge?

A filter wrench is needed to remove the oil filter cartridge.

What should be done before installing a new oil filter cartridge?

The filter holder should be cleaned, and the new filter cartridge should be filled with clean oil before installation.

Why is it important to check for old packing on the filter holder?

Old packing on the filter holder can cause improper sealing and oil leakage, so it must be removed before installing the new filter.

How tight should the oil filter cartridge be installed?

The oil filter cartridge should be tightened 3/4 to one full turn after the packing touches the surface of the filter holder. Over-tightening can damage the packing, while under-tightening can cause leaks.

How should the engine oil level be checked after refilling?

The oil dipstick should be removed, cleaned, reinserted, and then checked to ensure the oil level is between the full and low marks.

What should be done after refilling the oil and before finalizing the oil change?

Start the engine for a short time at idle speed, then turn it off and recheck the oil level with the dipstick. Also, inspect for any leaks from the filter seals.