Cylinder Install Lycoming O360 Engine
Summary
TLDRIn this video, the team at the engine shop demonstrates the installation of new cylinders on a Lycoming O360 engine during an overhaul. Viewers are encouraged to subscribe for updates on their Cessna 150 restoration series. The process begins with preparing the cylinders, including installing a base O-ring and securing piston pins with assembly grease. The connecting rod is aligned at top dead center, allowing the cylinder to slide over the piston. The video concludes with a reminder to subscribe for more content, showcasing the intricate steps involved in engine maintenance.
Takeaways
- π The video showcases the installation of new cylinders on a Lycoming O360 engine.
- π The channel invites viewers to subscribe to stay updated on upcoming content.
- π Viewers are encouraged to like the video to show support.
- π Preparation of the new cylinders includes installing a cylinder base O-ring.
- π Pistons are pulled back to allow for the installation of the piston pins.
- π Assembly grease is applied to facilitate the installation of piston pins.
- π The connecting rod must be brought to top dead center before installing the cylinder.
- π After aligning the connecting rod, the cylinder is pushed down over the piston.
- π The final steps involve installing and torquing the cylinder base nuts.
- π The video concludes with a thank you message and an invitation to subscribe for more content.
Q & A
What type of engine is being overhauled in this video?
-The video focuses on the overhaul of a Lycoming 0360 engine.
What components are being installed in this engine?
-Brand new cylinders are being installed on the Lycoming 0360 engine.
What series is mentioned in relation to the Cessna 150?
-The video is part of a restoration series for a Cessna 150.
What is the first step in installing the new cylinders?
-The first step is preparing the new cylinders, which includes installing the cylinder base O-ring.
How are the piston pins installed into the pistons?
-The pistons are pulled back out of the cylinder just far enough to slide the piston pin into the piston, followed by applying assembly grease before installation.
What is done after bringing the connecting rod to top dead center?
-After reaching top dead center, the pin is slid into the rod, and the cylinder is pushed down over the piston into the cylinder hole.
What is the final step mentioned for the cylinder installation?
-The final step is to install the cylinder base nuts and bring them up to torque.
How many cylinders does the speaker mention installing?
-The speaker mentions repeating the installation process for a total of four cylinders.
What does the speaker encourage viewers to do at the beginning of the video?
-The speaker encourages viewers to subscribe to the channel to avoid missing future videos.
What does the video conclude with?
-The video concludes by thanking viewers for watching and encouraging them to subscribe for more content.
Outlines
This section is available to paid users only. Please upgrade to access this part.
Upgrade NowMindmap
This section is available to paid users only. Please upgrade to access this part.
Upgrade NowKeywords
This section is available to paid users only. Please upgrade to access this part.
Upgrade NowHighlights
This section is available to paid users only. Please upgrade to access this part.
Upgrade NowTranscripts
This section is available to paid users only. Please upgrade to access this part.
Upgrade NowBrowse More Related Video
Cara Pemasangan Blok Piston Motor Revo
Mengenal Bagian-bagian Mesin Motor Secara Detal Sampai Ke Baut-Bautnya
New Car Break-In Recommendations: Manufacturer vs "Engine Builder"
chevy silverado 4.3l vortec (TDC) distributor install & where 2 point the rotor
Toyota Camry Rear Brake Pad Replacement With Electronic Brake 2018 - 2023
How To Set Valve Lash On A 6.6 Duramax Diesel Engine
5.0 / 5 (0 votes)